Logs should be milled for drying as soon as possible, and the ends should be sealed as soon as they are felled. The waste created by a chainsaw mill is more than that created by a bandsaw mill. Logs can be sawn for different lengths. They should be closer to your intended length than you think. This is the most difficult part of log cutting.
You will need to be able to cut the log to a depth of about 3/8″. If you can’t cut it to this depth, you will have to use a saw or a chisel to get it down to your desired depth. It is best to have a log saw on hand for this task, as it will make the job much easier.
Once you have cut your log, it is time to put it in the sawmill. The saw will take the logs and cut them into lengths that will fit in your saw. Be sure to keep your logs in a cool, dry place to prevent them from drying out too much. When you are done with your cut, put the cut log into the mill and let it dry for a few hours.
Table of Contents
What is a log dog tool?
Dogs are a device for holding a log in place while it is being worked on. They are typically made from metal and can either be driven into the wood by hand or a mechanical device.
How long should you let logs dry before milling?
Most lumber is between 1” and 2” in thickness. Drying cants, timbers, posts will take a long time. The answer to this question depends on many factors, including the type of wood, the amount of moisture in it, how long it has been exposed to the air, and how much moisture has evaporated from the wood.
For example, if you have a 2′ x 4′ board, you can expect to have it dry in about 4 weeks. If it is a 1/2″ x 3/4″ board you will have to wait about 3 months for it to be dry enough for you to work on it.
This is because the moisture content of a board will vary depending on how it was treated during the drying process. In general, wood will dry faster in a dryer environment than it does in an air-dried environment. However, this is not always the case, especially if the board is treated with a moisture-absorbing agent such as polyurethane foam.
Is milling your own lumber worth it?
Milling your own lumber can produce quality material for a fraction of the price of a lumber dealer. If you purchase your own mill, you can make a profit by selling lumber to other woodworkers and by offering to cut the lumber for them.
How much is a board foot of lumber worth?
In 2016, the total value of the timber harvest was estimated to be $4.2 billion. This increase was primarily due to higher prices for hardwood and softwood, as well as a decrease in prices of other types of forest products, such as pine, spruce, and cedar.
As a result of this increase in timber prices, total revenue from timber sales decreased by $100 million in fiscal year 2016 compared to the prior year, due primarily to lower sales of hardwoods and softerwood.